VEHICLE APPROACHING SPEAKER SWITCH INSPECTION

PROCEDURE

1. INSPECT VEHICLE APPROACHING SPEAKER SWITCH

   

   *a	Component without harness connected (Vehicle Approaching Speaker Switch)
   *b	Indicator
   *c	Illumination

   
   

   1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition 3 (IG) - 6 (ECU) Switch on 25 Ω or less Switch off 10 kΩ or higher

      If the result is not as specified, replace the vehicle approaching speaker switch.

   2. Illumination Inspection

      
      

      1. Apply auxiliary battery voltage to the vehicle approaching speaker switch and check that the switch illuminates.

         OK
         Condition Specified Condition Auxiliary battery positive (+) → Terminal 5 (ILL+) Auxiliary battery negative (-) → Terminal 4 (ILL-) Illuminates

         If the result is not as specified, replace the vehicle approaching speaker switch.

   3. Indicator Inspection

      
      

      1. Apply auxiliary battery voltage to the vehicle approaching speaker switch and check that the indicator illuminates.

         OK
         Condition Specified Condition Auxiliary battery positive (+) → Terminal 3 (IG) Auxiliary battery negative (-) → Terminal 7 (IND) Illuminates

         If the result is not as specified, replace the vehicle approaching speaker switch.