HEADLIGHT LEVELING ECU REMOVAL

PROCEDURE

1. PRECAUTION (w/ AVS)

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

   Click here

2. REMOVE BATTERY SERVICE HOLE COVER LH (w/ AVS)

   Click here

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ AVS)

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for LHD)

   Click here

5. REMOVE FRONT NO. 1 CONSOLE BOX INSERT (for LHD)

   Click here

6. REMOVE FRONT DOOR SCUFF PLATE LH

   Click here

7. REMOVE FRONT DOOR OPENING TRIM COVER LH

   Click here

8. REMOVE FLOOR CARPET HOOK (for LHD)

   Click here

9. REMOVE ACCELERATOR PEDAL PAD (for LHD)

   Click here

10. REMOVE ACCELERATOR PEDAL ASSEMBLY (for LHD)

    Click here

11. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

12. REMOVE ACCELERATION SENSOR (w/ AVS)

    Click here

13. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY

    
    

    1. for LHD:

       
       

       1. 

          Using a clip remover, disengage the 2 clips.

       2. Turn back the front floor mat as shown in the illustration.

       3. 

          Disengage the 2 clamps to remove the No. 3 dash panel insulator pad.

    2. for RHD:

       
       

       1. 

          Using a clip remover, disengage the clip.

       2. Turn back the front floor mat as shown in the illustration.

    3. 

       Using a clip remover, disengage the 2 clips to disconnect the connector holder.

    4. 

       *a	Clamp
       *b	Guide
       	Nut
       	Bolt

       Disconnect the connector.

    5. Disengage the clamp.

    6. Remove the nut and bolt.

    7. Disengage the guide to remove the headlight leveling ECU assembly.