HEADLIGHT LEVELING ECU INSTALLATION

PROCEDURE


  1. INSTALL HEADLIGHT LEVELING ECU ASSEMBLY


    1. Engage the guide to temporarily install the headlight leveling ECU assembly.

    2. Install the headlight leveling ECU assembly with the bolt and nut.

    3. Engage the clamp.

    4. Connect the connector.

    5. Engage the 2 clips to connect the connector holder.

    6. for LHD:


      1. Engage the 2 clamps to install the No. 3 dash panel insulator pad.

      2. A01MTNO

        Install the front floor mat to the original position as shown in the illustration.

      3. Engage the 2 clips.

    7. for RHD:


      1. A01MSH7

        Install the front floor mat to the original position as shown in the illustration.

      2. Engage the clip.

  2. INSTALL ACCELERATION SENSOR (w/ AVS)

    Click here

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here

  4. INSTALL ACCELERATOR PEDAL ASSEMBLY (for LHD)

    Click here

  5. INSTALL ACCELERATOR PEDAL PAD (for LHD)

    Click here

  6. INSTALL FLOOR CARPET HOOK (for LHD)

    Click here

  7. INSTALL FRONT DOOR OPENING TRIM COVER LH

    Click here

  8. INSTALL FRONT DOOR SCUFF PLATE LH

    Click here

  9. INSTALL FRONT NO. 1 CONSOLE BOX INSERT (for LHD)

    Click here

  10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for LHD)

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/ AVS)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  12. INSTALL BATTERY SERVICE HOLE COVER LH (w/ AVS)

    Click here

  13. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL

    Click here

  14. ADJUST HEADLIGHT AIMING (for HID Headlight)

    Click here

  15. ADJUST HEADLIGHT AIMING (for LED Headlight)

    Click here