HEIGHT CONTROL SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE REAR WHEEL LH

  5. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    1. A00213TC02
      B003YHT Bolt
      B003XOB Nut

      Disconnect the connector.

    2. Disengage the clamp.

    3. Remove the 2 bolts, nut and rear height control sensor sub-assembly.

      Note

      Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.