RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT HORN RELAY


    1. A011NOIC02
      *a

      Component without harness connected

      (Horn Relay)

      Remove the horn relay.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Auxiliary battery voltage is not applied between terminals 1 and 2 10 kΩ or higher
      3 - 5 Auxiliary battery voltage is applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the horn relay.