CLEARANCE LIGHT ASSEMBLY DISASSEMBLY

PROCEDURE


  1. REMOVE CLEARANCE LIGHT LENS

    Note


    • Make sure to wear clean rubber gloves when performing this procedure.

    • Do not allow dirt or foreign matter to get on the clearance light lens.

    • If there are any fingerprints or foreign matter on the back of the clearance light lens, wipe them off with a soft cloth.


    1. A0021QS

      Using a T20H "TORX" driver, remove the 3 "TORX" screws.

    2. A0021RX

      Remove the 3 screws.

    3. A002083

      Using a hair dryer, heat the backside of the clearance light assembly.

      Note

      If the clearance light assembly is heated unevenly, it will deform or melt.

    4. A0022KQ

      Disengage the 6 claws.

    5. Remove the clearance light lens from the housing.

      Tech Tips

      If the clearance light lens cannot be removed even after heating, using a screwdriver with its tip wrapped with protective tape, lift the clearance light lens. Be careful not to damage the clearance light lens and housing.

  2. REMOVE CLEARANCE LIGHT LENS GASKET


    1. A0020A2

      Remove the clearance light lens gasket from the housing.

      Note

      Make sure to replace the clearance light lens gasket with a new one. Failure to do so may cause water ingress.

  3. REMOVE CLEARANCE LIGHT LED UNIT ASSEMBLY

    Note


    • Make sure to wear clean rubber gloves when performing this procedure.

    • Do not allow dirt or foreign matter to get on the clearance light LED unit assembly or other components.

    • If there are any fingerprints or foreign matter on the clearance light LED unit assembly or other components, wipe them off with a soft cloth.


    1. A0022G1

      Remove the 3 screws.

    2. Disengage the 2 guides to separate the clearance light LED unit assembly.

    3. A0021A2

      Disengage the 3 clamps.

    4. Disconnect the 2 connectors to remove the clearance light LED unit assembly from the housing.