HEADLIGHT ASSEMBLY(for HID Headlight) INSPECTION

PROCEDURE


  1. INSPECT HEADLIGHT CORD RH


    1. Disconnect the headlight cord RH.

      A011P3FC05
      *a

      Component without harness connected

      (Headlight Cord RH)

      		 - -

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A1-2 (RH E) - LVR-1 Always Below 1 Ω
      A1-1 (RH T) - LVR-2 Always Below 1 Ω
      A1-4 (RHIG) - LVR-3 Always Below 1 Ω

      If the result is not as specified, replace the headlight cord RH.

    3. Reconnect the headlight cord RH to the headlight unit RH.

    4. Apply auxiliary battery voltage to the headlight cord RH and check that the light comes on.

      OK
      Condition Specified Condition

      Auxiliary battery positive (+) → A1-6 (B)

      Auxiliary battery negative (-) → A1-3 (E)

      		 Turn signal light RH comes on

      If the result is not as specified, replace the headlight cord RH or bulb.

  2. INSPECT HEADLIGHT CORD LH


    1. Disconnect the headlight cord LH.

      A011P3FC06
      *a

      Component without harness connected

      (Headlight Cord LH)

      		 - -

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A33-2 (LH E) - LVL-1 Always Below 1 Ω
      A33-1 (LH T) - LVL-2 Always Below 1 Ω
      A33-4 (LHIG) - LVL-3 Always Below 1 Ω

      If the result is not as specified, replace the headlight cord LH.

    3. Reconnect the headlight cord LH to the headlight unit LH.

    4. Apply auxiliary battery voltage to the headlight cord RH and check that the light comes on.

      OK
      Condition Specified Condition

      Auxiliary battery positive (+) → A33-6 (B)

      Auxiliary battery negative (-) → A33-3 (E)

      		 Turn signal light LH comes on

      If the result is not as specified, replace the headlight cord LH or bulb.