HEADLIGHT ASSEMBLY(for Bulb Type Turn Signal Light) REPAIR

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

  • Ensure that the headlight assembly is not damaged.

PROCEDURE


  1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER


    1. B003XPD

      Remove the screw.

      Note

      Do not reuse the removed screw.

    2. Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Tech Tips

      After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    3. B003YSMC01
      *a Screw (A)
      *b Screw (B)

      Install the upper headlight protector retainer with the 2 screws (A) and screw (B).

      Note

      Make sure to use only the screws which were supplied with the upper headlight protector retainer.

      Diameter Length
      Screw (A) 3 mm (0.118 in.) 12 mm (0.472 in.)
      Screw (B) 5 mm (0.197 in.) 16 mm (0.630 in.)