AUTOMATIC HIGH BEAM SYSTEM TEST MODE PROCEDURE


  1. AUTOMATIC HIGH BEAM SYSTEM OPERATION CHECK

    Tech Tips

    This mode is to check the automatic high beam system operation with the vehicle stationary, based on the high beam illumination request signal from the lane departure warning camera. Check that none of the conditions below are met before proceeding with the following procedure.


    • The system is in the start-up process, immediately after the power switch is turned on (IG). (Standby mode is not determined.)

    • The camera is temporarily unavailable due to high temperature, etc. (The lane departure warning camera cannot detect properly.)

    • The lane departure warning camera is malfunctioning.

    • The camera cannot monitor the light level properly due to camera axis misalignment.


    1. Place the vehicle in an area dark enough for the automatic high beam system to operate.

    2. Turn the power switch on (IG).

    3. Turn the light control switch to the AUTO or HEAD position to turn on the headlights.

    4. Press the auto high beam switch to put the automatic high beam system in standby mode.

    5. Turn the power switch off.

    6. Within 5 seconds of turning the power switch on (IG), perform the following operation with the automatic high beam system in standby mode:

      Move the dimmer switch to the high position and then change the dimmer switch position from high to low 9 times.

      Tech Tips


      • The dimmer switch should be in the high position when this step is complete.

    7. Check that the high beam headlights come on.

      Tech Tips

      Test mode will be canceled when any of the following operations are performed:


      • The power switch is turned off.

      • The light control switch is not in the AUTO or HEAD position.

      • The dimmer switch is not in the high position.

      • The auto high beam switch is pressed again.