| DTC Code | DTC Name |
|---|---|
| B2415 | Vehicle Speed Sensor |
DESCRIPTION
The No. 1 headlight ECU sub-assembly LH receives signals indicating the vehicle speed signal from the skid control ECU using CAN communication. The No. 1 headlight ECU sub-assembly LH stores DTC B2415.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2415 | Vehicle Speed Sensor | Malfunction in vehicle speed signal |
|
WIRING DIAGRAM
| *1 | Skid Control ECU |
| *2 | No. 1 Headlight ECU Sub-assembly LH |
| *3 | CAN Communication Line |
CAUTION / NOTICE / HINT
Note
Confirm that there are no CAN communication system malfunctions before performing the following procedure.
If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.
PROCEDURE
CLEAR DTC
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Clear the DTCs.
| Result | ||
|---|---|---|
|
| NEXT |
|
CHECK FOR DTC
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.
Check for DTCs.
| OK |
|---|
| DTC B2415 is not output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Check for DTCs.
| OK |
|---|
| Electronically controlled brake system DTCs are not output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH Click here |
| NG |
|
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Click here |