AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM, Diagnostic DTC:B2450

DTC Code DTC Name
B2450 Height Sensor Initialization Incomplete

DESCRIPTION

The No. 1 headlight ECU sub-assembly LH stores this DTC if initialization has not been performed after the ECU was replaced.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2450 Height Sensor Initialization Incomplete Initialization of the No. 1 headlight ECU sub-assembly LH has not been performed No. 1 headlight ECU sub-assembly LH

CAUTION / NOTICE / HINT

Note

If the No. 1 headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the No. 1 headlight ECU sub-assembly LH.

Click here

PROCEDURE


  1. INITIALIZATION NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH


    1. Perform initialization of the No. 1 headlight ECU sub-assembly LH.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  2. CLEAR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

    5. Clear the DTCs.


      Body Electrical > HL AutoLeveling > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK FOR DTC


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / HL AutoLeveling / Trouble Codes.

    5. Check for DTCs.


      Body Electrical > HL AutoLeveling > Trouble Codes
      OK
      DTC B2450 is not output.

      Tech Tips

      If the No. 1 headlight ECU sub-assembly LH stores DTC B2450 even though the ECU has been initialized, there may be a malfunction in the No. 1 headlight ECU sub-assembly LH.

      Result
      Proceed to
      OK
      NG

    OK

    END (INITIALIZATION WAS NOT COMPLETED)

    NG

    REPLACE NO. 1 HEADLIGHT ECU SUB-ASSEMBLY LH Click here