LIGHTING SYSTEM Parking Brake Switch Circuit

DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the parking brake switch assembly.

WIRING DIAGRAM

B003XP0E02
*a Instrument Panel Junction Block Assembly
*b Parking Brake Switch Assembly
*c Main Body ECU (Multiplex Network Body ECU)

CAUTION / NOTICE / HINT

Note

Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

PROCEDURE


  1. READ VALUE USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the display on the GTS.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Parking Brake SW Parking brake switch signal ON or OFF

      ON: Parking brake switch on

      OFF: Parking brake switch off

      		 -

      Body Electrical > Main Body > Data List
      Tester Display
      Parking Brake SW
      OK
      Normal conditions listed above are displayed.
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. INSPECT PARKING BRAKE SWITCH ASSEMBLY


    1. Remove the parking brake switch assembly.

      for LHD: Click here

      for RHD: Click here

    2. Inspect the parking brake switch assembly.

      for LHD: Click here

      for RHD: Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE PARKING BRAKE SWITCH ASSEMBLY for LHD: Click here
    REPLACE PARKING BRAKE SWITCH ASSEMBLY for RHD: Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)


    1. Disconnect the 4C instrument panel junction block assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A51-1 (+) - 4C-15 Always Below 1 Ω
      A51-1 (+) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. Remove the instrument panel junction block assembly.

      Click here

    2. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

    3. Measure the resistance according to the value(s) in the table below.

      B003Y2XC04
      *a

      Component without harness connected

      (Instrument Panel Junction Block Assembly)

      		 - -
      Standard Resistance
      Tester Connection Condition Specified Condition
      4C-15 - MB-12 (PKB) Always Below 1 Ω
      4C-15 - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

    NG

    REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY Click here