OUTER REAR VIEW MIRROR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY


    1. Engage the claw to temporarily install the outer rear view mirror assembly.

    2. Install the outer rear view mirror assembly with the 3 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Engage the clamp.

    4. w/o Memory:


      1. Connect the connector.

    5. Install the 2 hole plugs.

  2. INSTALL OUTER MIRROR PROTECTOR


    1. A00222HC01
      *a Clamp
      *b Seal

      Engage the 2 claws to temporarily install the outer mirror protector.

    2. Install the outer mirror protector with the screw.

    3. Engage the clamp to connect the wire harness as shown in the illustration.

  3. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY (w/ Memory)

    Click here

  4. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

  5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  7. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  8. INSTALL FRONT DOOR ARMREST COVER

    Click here

  9. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  10. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  12. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  13. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here