PROCEDURE
INSPECT COMBINATION METER ASSEMBLY
Check speedometer operation
Note
The combination meter assembly receives the vehicle speed signal from the skid control ECU assembly via CAN communication. Therefore, perform the following inspection referring to values on the Data List of the skid control ECU assembly because it is the source of the vehicle speed signal.
Data List values of the skid control ECU assembly are used for this inspection. Therefore, make sure to perform this inspection after confirming that DTCs are not output.
If the tire size or tire inflation pressure is not within the specified range, or the tires are excessively worn, the speedometer indication error will increase. Therefore, make sure to perform this inspection after checking that the tire size, tire inflation pressure and tire wear are in the specified range.
Before starting the following inspection, check if vehicle stability control system DTCs are output.
Check the values by referring to the table below.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Vehicle Speed | Maximum wheel speed sensor reading | Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) | Vehicle stopped: 0 km/h (0 mph) | When driving at constant speed: No large fluctuations |
| Tester Display |
|---|
| Vehicle Speed |
except F SPORT models
| GTS Indication (km/h) | Acceptable Range (km/h) |
|---|---|
| 20 | 21.0 to 25.0 |
| 40 | 41.7 to 46.2 |
| 60 | 62.7 to 67.2 |
| 80 | 83.4 to 88.4 |
| 100 | 104.3 to 109.3 |
| 120 | 125.1 to 130.6 |
| 140 | 145.8 to 151.8 |
| 160 | 166.2 to 173.2 |
| 180 | 186.9 to 194.5 |
| 200 | 207.7 to 215.7 |
| 220 | 228.4 to 236.8 |
| 240 | 249.2 to 258.0 |
| 260 | 250.0 to 279.2 |
| GTS Indication (mph) | Acceptable Range (mph) |
|---|---|
| 20 | 21.0 to 23.5 |
| 40 | 42.0 to 44.5 |
| 60 | 62.5 to 66.0 |
| 80 | 83.1 to 87.1 |
| 100 | 103.9 to 108.4 |
| 120 | 124.7 to 129.6 |
| 140 | 145.4 to 150.7 |
| 160 | 166.2 to 171.9 |
for F SPORT models
| GTS Indication (km/h) | Acceptable Range (km/h) |
|---|---|
| 20 | 21 to 25 |
| 40 | 42 to 46 |
| 60 | 63 to 67 |
| 80 | 84 to 88 |
| 100 | 104 to 109 |
| 120 | 125 to 130 |
| 140 | 146 to 151 |
| 160 | 167 to 173 |
| 180 | 187 to 194 |
| 200 | 208 to 215 |
| 220 | 229 to 236 |
| 240 | 249 to 257 |
| 260 | 270 to 278 |
| GTS Indication (mph) | Acceptable Range (mph) |
|---|---|
| 20 | 21 to 23 |
| 40 | 42 to 44 |
| 60 | 63 to 66 |
| 80 | 83 to 87 |
| 100 | 104 to 108 |
| 120 | 125 to 129 |
| 140 | 146 to 150 |
| 160 | 166 to 171 |
Inspect tachometer
Connect the GTS and start the engine.
Compare the test results with the tachometer indication.
| GTS Indication (rpm) | Acceptable Range (rpm) Data in ( ) is for Reference |
|---|---|
| 700 | 630 to 770 |
| 1000 | (900 to 1100) |
| 2000 | (1850 to 2150) |
| 3000 | 2800 to 3200 |
| 4000 | (3800 to 4200) |
| 5000 | 4800 to 5200 |
| 6000 | (5750 to 6250) |
| 7000 | 6700 to 7300 |
| 8000 | (7700 to 8300) |
Check LED illumination (LED check)
Check the illumination function of the warning or indicator lights listed below when turning the power switch on (IG).
| OK | |||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
*1: w/ Pre-crash System