METER / GAUGE SYSTEM FREEZE FRAME DATA


  1. FREEZE FRAME DATA


    1. Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.

  2. CHECK FREEZE FRAME DATA


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.

    5. According to the GTS display, select a DTC that stored freeze frame data.

    6. Read the freeze frame data recorded when the DTC was stored.

      Combination Meter
      Tester Display Condition Displayed Item
      B1507 Open in Turn Signal Circuit

      • Trip

      • Elapsed time after turning the power switch on (IG)
      B1508 Short in Turn Signal / Hazard Flasher Circuit
      B150A Lost Communication with HMI-LAN
      B150B Lost Communication with Gigabit Video Interface
      B150C Lost Communication with LIN
      U0100 Lost Communication with ECM / PCM "A"
      U0129 Lost Communication with Brake System Control Module
      U0131 Lost Communication with Power Steering Control Module
      U0142 Lost Communication with Body Control Module "B"
      U0151 Lost Communication with Restraints Control Module
      U0163 Lost Communication with Navigation Control Module
      U0182 Lost Communication with AFC ECU
      U023A Lost Communication with Front Camera Module
      U1104 Lost Communication with Driving Support ECU

  3. CLEAR FREEZE FRAME DATA

    Note

    Clearing the DTCs will also clear the freeze frame data.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Clear DTCs and freeze frame data.

      Click here


      Body Electrical > Combination Meter > Clear DTCs