THEFT DETERRENT SYSTEM Engine Hood Courtesy Switch Circuit

DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock assembly. This switch turns on when the engine hood is closed and turns off when the engine hood is opened.

WIRING DIAGRAM

A0022MBE02
*a Engine Hood Courtesy Switch (Hood Lock Assembly)
*b Main Body ECU (Multiplex Network Body ECU)

CAUTION / NOTICE / HINT

Note

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.

PROCEDURE


  1. READ VALUE USING GTS (HOOD COURTESY SW)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Hood Courtesy SW Engine hood courtesy switch ON or OFF

      ON: Engine hood open

      OFF: Engine hood closed

      		 -

      Body Electrical > Main Body > Data List
      Tester Display
      Hood Courtesy SW
      OK
      The GTS display changes correctly in response to the engine hood courtesy switch (hood lock assembly) status.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

    NG

  2. INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


    1. Remove the hood lock assembly.

      Click here

    2. Inspect the engine hood courtesy switch (hood lock assembly).

      Click here

      Result
      Proceed to
      OK
      NG

    NG

    REPLACE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) - ENGINE HOOD COURTESY SWITCH - BODY GROUND)


    1. Disconnect the K2 main body ECU (multiplex network body ECU) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K2-11 (HCTY) - B9-1 Always Below 1 Ω
      K2-11 (HCTY) - Body ground Always 10 kΩ or higher
      B9-1 - Body ground Always 10 kΩ or higher
      B9-2 - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR