IMMOBILISER SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following systems after the cable is reconnected.

    System Name See Procedure
    Air Conditioning System

    Click here

    Parking Assist Monitor System

  2. PRECAUTIONS WHEN USING GTS


    1. When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  3. PRECAUTION FOR REGISTRATION


    1. If replacing any of the following parts, refer to Service Bulletin.


      1. Certification ECU (smart key ECU assembly)

      2. ID code box (immobiliser code ECU)

      3. Steering lock ECU (steering lock actuator assembly)

      4. Electrical key transmitter sub-assembly

      5. Power management control ECU

      6. Main body ECU (multiplex network body ECU)

  4. PRECAUTIONS FOR AUXILIARY BATTERY


    1. Immediately after disconnecting and reconnecting the auxiliary battery cable, the entry unlock function may not operate. If this occurs, the entry unlock function can be restored by performing a wireless door lock and unlock or mechanical key operation.

    2. When the auxiliary battery is discharged, if the 12V battery of another vehicle is used to jump start the hybrid control system, move the shift lever to P and open and close the driver door with the power switch off before starting the hybrid control system.

    3. After the auxiliary battery is removed and reinstalled, be sure to wait 10 seconds or more before the next hybrid control system start. The hybrid control system may not start immediately after the auxiliary battery is reinstalled.

      Tech Tips


      • After disconnecting and reconnecting the auxiliary battery cable, the hybrid control system may not start on the first attempt. If this occurs, turn the power switch off. The hybrid control system will start normally from the second time onward.

      • When the auxiliary battery cable is disconnected and reconnected, the power source mode returns to the mode it was in before the auxiliary battery cable was disconnected.