PUSH-BUTTON START Entry Interior Alarm does not Sound

DESCRIPTION

The push-button start uses the buzzer in the combination meter assembly (meter ECU) to perform various vehicle interior warnings. When the conditions of each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer activation request signal to the combination meter assembly via CAN communication and the buzzer sounds.

CAUTION / NOTICE / HINT

Note


  • The push-button start uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the push-button start after confirming that the communication systems are functioning properly.

    Click here

  • When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

    Click here

PROCEDURE


  1. CHECK PUSH-BUTTON START


    1. Check that the push-button start functions operate.

      Click here

      OK
      Push-button start functions operate normally.
      Result
      Proceed to
      OK
      NG

    OK

    GO TO METER / GAUGE SYSTEM Click here

    NG

    GO TO OTHER PROBLEM Click here