PUSH-BUTTON START, Diagnostic DTC:B2277

DTC Code DTC Name
B2277 Detecting Vehicle Submersion

DESCRIPTION

This DTC is stored when a malfunction in the water submersion detection circuit in the power management control ECU is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B2277 Detecting Vehicle Submersion The water submersion detection circuit in the power management control ECU detects water submersion (1-trip detection logic*). Power management control ECU

    DTC Output Confirmation Operation:

  • Wait 300 seconds after connecting the cable to the negative (-) auxiliary battery terminal.

Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
The power switch cannot be turned off and the hybrid control system cannot be started. -
Related Data List and Active Test Items
DTC No. Data List and Active Test
B2277 -

CAUTION / NOTICE / HINT

Note


  • When using the GTS with the power switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • The push-button start uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the push-button start after confirming that the communication systems are functioning properly.

    Click here

  • Before replacing the power management control ECU, refer to push-button start Precaution.

    Click here

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

Tech Tips


  • Before proceeding with troubleshooting, check if there are any signs of water damage to the power management control ECU. If there are any signs of water damage, replace the power management control ECU and take measures against the cause of the water damage.

  • When the cable is disconnected and reconnected to the negative (-) auxiliary battery terminal, the power source mode returns to the state it was in before the cable was disconnected.

PROCEDURE


  1. CHECK WATER INTRUSION


    1. Check that the power management control ECU, its surrounding area and wire harnesses have no signs of water intrusion.

      Result
      Result Proceed to
      No sign of water intrusion found A
      Signs of water intrusion found B

    A

    REPLACE POWER MANAGEMENT CONTROL ECU Click here

    B

    TAKE MEASURES FOR WATER INTRUSION AND REPLACE POWER MANAGEMENT CONTROL ECU Click here