FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

   Click here

2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

   Click here

3. INSTALL FRONT DOOR LOCK WITH MOTOR ASSEMBLY

   Note

   
   

   • When reusing a removed front door lock with motor assembly, replace the door lock wire harness seal on the connector with a new one.

   • Do not allow grease or dust to adhere to the door lock wire harness seal installation surface of the connector.

   • Reusing the door lock wire harness seal or using a damaged door lock wire harness seal may cause water ingress. This may result in a malfunction of the front door lock with motor assembly.

   
   

   1. Apply MP grease to the sliding parts of the front door lock with motor assembly.

   2. When reusing the front door lock with motor assembly:

      
      

      1. Install a new door lock wire harness seal to the front door lock with motor assembly.

   3. 

      *1	Front Door Lock Open Rod

      Connect the front door lock open rod to the front door lock with motor assembly.

      Tech Tips

      Make sure that the front door lock open rod is securely connected to the front door lock with motor assembly.

   4. Using a T30 "TORX" socket wrench, install the front door lock with motor assembly with the 3 screws.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   5. Connect the connector.

4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

   Click here

5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

   Click here

6. INSTALL FRONT DOOR GLASS RUN

   Click here

7. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

   Click here

8. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

   Click here

9. INSTALL FRONT DOOR SERVICE HOLE COVER

   Click here

10. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP

    Click here

11. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

12. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

13. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

14. INSTALL FRONT DOOR ARMREST COVER

    Click here

15. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

16. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

17. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

19. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here

20. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

21. INSPECT POWER WINDOW OPERATION

    Click here