DOOR CONTROL SWITCH INSPECTION

PROCEDURE


  1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY


    1. A011NFCC02
      *a Lock
      *b Unlock
      *c

      Component without harness connected

      (Power Window Regulator Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      12 (L) - 5 (GND) Lock switch pushed Below 1 Ω
      12 (L) - 5 (GND) Lock switch not pushed 10 kΩ or higher
      7 (UL) - 5 (GND) Unlock switch pushed Below 1 Ω
      7 (UL) - 5 (GND) Unlock switch not pushed 10 kΩ or higher

      If the result is not as specified, replace the power window regulator switch assembly.