WIRELESS DOOR LOCK CONTROL SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • The wireless door lock control system troubleshooting procedure is based on the premise that the power door lock control system is operating properly. Check the power door lock control system first before troubleshooting the wireless door lock control system. Use this procedure to troubleshoot the wireless door lock control system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. CUSTOMER PROBLEM ANALYSIS CHECK

    Tech Tips


    • In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

    • Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

    • The following 5 items are important points for problem analysis:

    What Vehicle model, system name
    When Date, time, occurrence frequency, whether the problem occurred recently or has been occurring for a long time
    Where Whether the problem occurs at a specific location
    Under what conditions? Whether the doors were locked or unlocked, whether the power switch was on, whether the hybrid control system was starting
    How did it happen? Problem symptoms
    Result
    Proceed to
    NEXT

    NEXT

  3. PRE-CHECK


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

    2. Check the fuses and relays.

    3. Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.

      Result
      Proceed to
      NEXT

    NEXT

  4. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Using the GTS, check for CAN communication system DTCs.

      Click here

      Result
      Result Proceed to
      CAN DTCs are not output A
      CAN DTCs are output B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  5. CHECK FOR DTC (WIRELESS DOOR LOCK CONTROL SYSTEM)*


    1. Clear the DTCs.

      Click here


      Body Electrical > Entry&Start > Clear DTCs

    2. Recheck for DTCs.


      Body Electrical > Entry&Start > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here

    A

  6. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

    B

    GO TO STEP 8 Click here

    A

  7. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Terminals of ECU

      Click here

    2. Data List / Active Test

      Click here

    3. Operation Check

      Click here

    4. Inspection

      Result
      Proceed to
      NEXT

    NEXT

  8. REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  9. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END