NETWORK GATEWAY ECU REMOVAL

CAUTION / NOTICE / HINT

Note


  • When disassembling the network gateway ECU, eliminate static electricity by touching the vehicle body to prevent the components from being damaged.

  • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  2. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for RHD)

    Click here

  4. REMOVE FRONT NO. 2 CONSOLE BOX INSERT (for LHD)

    Click here

  5. REMOVE FRONT NO. 1 CONSOLE BOX INSERT (for RHD)

    Click here

  6. REMOVE FRONT DOOR SCUFF PLATE RH (for LHD)

    Click here

  7. REMOVE FRONT DOOR SCUFF PLATE LH (for RHD)

    Click here

  8. REMOVE FRONT DOOR OPENING TRIM COVER RH (for LHD)

    Click here

  9. REMOVE FRONT DOOR OPENING TRIM COVER LH (for RHD)

    Click here

  10. REMOVE INSTRUMENT SIDE PANEL RH (for LHD)

    Click here

  11. REMOVE INSTRUMENT SIDE PANEL LH (for RHD)

    Click here

  12. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  13. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

  14. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

  15. REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)


    1. A0021DY

      Disconnect the connector to remove the central gateway ECU (network gateway ECU).

    2. Remove the 2 screws and central gateway ECU (network gateway ECU) from the blower assembly.