ULTRASONIC SENSOR(for Rear Side) INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this procedure only when replacement of the No. 1 ultrasonic sensor retainer is necessary.

    • If a No. 1 ultrasonic sensor retainer has been removed, replace it with a new one. Install the No. 1 ultrasonic sensor with a new No. 1 ultrasonic sensor retainer as a set to the rear bumper assembly.

    • Use the same procedure for all No. 1 ultrasonic sensor retainers.


    1. B003XRL

      Engage the 2 claws and install a new No. 1 ultrasonic sensor retainer to the No. 1 ultrasonic sensor.

    2. Clean the rear bumper assembly surface.


      1. Remove any remaining double-sided tape from the rear bumper assembly.

      2. Wipe off any tape adhesive residue with cleaner.

    3. B003XQHC03
      *a 18 mm (0.709 in.)

      Cover the sensor installation hole with a 18 mm (0.709 in.) circular piece of tape.

    4. B003YGUC02
      B003Y0W Primer

      Using a brush or felt, apply primer or equivalent to the No. 1 ultrasonic sensor retainer installation area.

      Note


      • Use a clean brush or felt.

      • Do not touch the rear bumper assembly until the primer has dried.

    5. Confirm that the primer has completely dried by touching the rear bumper assembly. Then remove the tape.

    6. Peel off the release paper from the new No. 1 ultrasonic sensor retainer.

    7. B003YKEC01
      *a Scribed line
      *b Protrusion of the mark

      Align the No. 1 ultrasonic sensor retainer with No. 1 ultrasonic sensor with the mark on the rear bumper assembly and install it as shown in the illustration.

      Note


      • Ensure that the sensor tip is correctly inserted into the sensor installation hole of the rear bumper assembly.

      • Ensure that the No. 1 ultrasonic sensor retainer is within the scribed line.

      • The double-sided tape of a No. 1 ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the No. 1 ultrasonic sensor retainer with a new one when reattachment is necessary.

      Tech Tips


      • Align the connector with the protrusion of the mark when connecting it.

      • Press the No. 1 ultrasonic sensor retainer with a force of 30 N (3.0 kgf) for 3 seconds and install the No. 1 ultrasonic sensor retainer firmly so that there is no clearance between the No. 1 ultrasonic sensor retainer and rear bumper assembly.

    8. Connect the connector.

  2. INSTALL NO. 1 ULTRASONIC SENSOR

    Tech Tips

    Use the same procedure for all No. 1 ultrasonic sensors.


    1. When replacing only the No. 1 ultrasonic sensor:


      1. Engage the 2 claws to install the No. 1 ultrasonic sensor.

      2. Connect the connector.

  3. INSTALL REAR BUMPER ASSEMBLY

    Click here