ULTRASONIC SENSOR(for Rear Side) INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 ULTRASONIC SENSOR

  2. INSTALL ULTRASONIC SENSOR CLIP


    1. A01CZ9N

      Engage the claw to install the ultrasonic sensor clip.

      Tech Tips

      Use the same procedure for all ultrasonic sensor clips.

  3. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

    Tech Tips


    • Perform this step only when necessary.

    • If a No. 1 ultrasonic sensor retainer has been removed, replace it with a new one. Install the ultrasonic sensor with clip with a new No. 1 ultrasonic sensor retainer as a set to the rear bumper assembly.

    • Use the same procedure for all No. 1 ultrasonic sensor retainer.


    1. A01CZMA

      Engage the 2 claws and install a new No. 1 ultrasonic sensor retainer to the ultrasonic sensor with clip.

    2. Clean the rear bumper cover surface.


      1. Remove the double-sided tape from the rear bumper cover.

      2. Wipe off any tape adhesive residue with cleaner.

    3. A01D01NC01
      B003Y0W Primer

      Using a brush or felt, apply primer or equivalent to the No. 1 ultrasonic sensor retainer installation area.

      Note


      • Use a clean brush or felt.

      • Do not touch the rear bumper assembly until the primer has dried.

    4. Peel off the release paper from the new No. 1 ultrasonic sensor retainer.

    5. A01CZHMC01
      *a Protrusion of the mark

      Align the No. 1 ultrasonic sensor retainer with ultrasonic sensor with the mark on the rear bumper cover and install it as shown in the illustration.

      Note

      The double sided tape of a No. 1 ultrasonic sensor retainer will deteriorate if it is detached. Make sure to replace the No. 1 ultrasonic sensor retainer with a new one when reattachment is necessary.

      Tech Tips


      • Align the connector with the protrusion of the mark and connect it.

      • Press on the areas indicated by the arrows in the illustration with a force of 30 N (3.0 kgf) for 3 seconds and install the No. 1 ultrasonic sensor retainer firmly so that there is no clearance between the No. 1 ultrasonic sensor retainer and rear bumper cover.

  4. INSTALL ULTRASONIC SENSOR WITH CLIP


    1. Engage the 2 claws to install the ultrasonic sensor with clip.

  5. INSTALL NO. 3 LUGGAGE ROOM WIRE

    Click here

  6. INSTALL REAR BUMPER ASSEMBLY

    Click here