PARKING ASSIST MONITOR SYSTEM(w/o Parallel Parking Assist Function), Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION

This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the spiral cable with sensor sub-assembly that indicates an internal malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the spiral cable with sensor sub-assembly

  • Spiral cable with sensor sub-assembly

  • Rear television camera assembly

CAUTION / NOTICE / HINT

Note


  • If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

PROCEDURE


  1. REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Replace the spiral cable with sensor sub-assembly with a new or known good one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK DTC OUTPUT


    1. Clear the DTCs.

      Click here


      Chassis > IPA/Parking Assist Monitor > Clear DTCs

    2. Recheck for DTCs and check that no DTCs are output.

      Click here


      Chassis > IPA/Parking Assist Monitor > Trouble Codes
      Result
      Result Proceed to
      DTC C1626 is output A
      DTC C1626 is not output B

    A

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here

    B

    END