Click here

PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function), Diagnostic DTC:C1625

Click here
Click here
DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B
Click here

DESCRIPTION

This DTC is stored if the radio receiver assembly receives a signal via CAN communication from the spiral cable with sensor sub-assembly that indicates a power supply problem.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1625 Open or Short in Steering Angle Sensor +B Open or short in spiral cable with sensor sub-assembly power source

  • Harness or connector

  • Spiral cable with sensor sub-assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY POWER SOURCE)


    1. Disconnect the K29 spiral cable with sensor sub-assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K29-1 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K29-4 (IG1) - K29-1 (ESS) Power switch on (IG) 11 to 14 V
      K29-8 (BAT) - K29-1 (ESS) Power switch off 11 to 14 V
      Result
      Proceed to
      OK
      NG

    • OK

      REPLACE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLYClick here

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR