TELEMATICS SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Telematics / Data List.

    5. According to the display on the GTS, read the "Data List".


      Body Electrical > Telematics > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      VIN VIN registered to the telematics transceiver 17 digits Vehicle VIN displayed -
      Unsent Emergency Call Number Number of times an emergency call has failed Min.: 0, Max.: 255 0 -
      Activation Status Telematics transceiver activation status Shipping(Disable), Shipping(Enable), Full Services, Full Services & F&I Service, eCall only eCall only -
      Backup Battery Status Mobilephone battery replacement flag Normal or Replace Normal -
      Number of Trouble Codes The number of the DTC which is currently output Min.: 0, Max.: 255 Number of stored DTCs displayed -

  2. Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    ACTIVE TEST


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Telematics / Active Test.

    5. According to the display on the GTS, perform the Active Test.


      Body Electrical > Telematics > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Beep Operate front No. 2 speaker assembly RH OFF, ON -

      Body Electrical > Telematics > Active Test
      Tester Display
      Beep