NOISE FILTER ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT RADIO SETTING CONDENSER (for High Mounted Stop Light)


    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. Remove the bolt.

    3. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. A011M2IC10
      *a Radio Setting Condenser

      Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      Note

      Before measuring the resistance and voltage, be sure to use insulated probes to avoid a short circuit between the tester terminal and bracket.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2

      • Power switch off

      • High mounted stop light off

      • Luggage compartment room light off

      		 10 kΩ or higher
      1 - 3 10 kΩ or higher
      1 - Body ground Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      2 - Body ground

      • Power switch on (IG)

      • High mounted stop light off

      		 Below 1 V
      3 - Body ground

      • Power switch on (IG)

      • Luggage compartment room light off

      		 Below 1 V
      2 - Body ground

      • Power switch on (IG)

      • High mounted stop light on

      		 11 to 14 V
      3 - Body ground

      • Power switch on (IG)

      • Luggage compartment room light off

      		 11 to 14 V

  2. INSPECT RADIO SETTING CONDENSER (for Window Defogger)


    1. With the radio setting condenser installed, check that there is no looseness or other abnormalities.

    2. Remove the bolt.

    3. Disengage the 2 clamps and disconnect the radio setting condenser with wire harness from the vehicle body.

    4. A011M2QC11
      *a Radio Setting Condenser

      Measure the resistance and voltage of the radio setting condenser according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2

      • Power switch off

      • Window Defogger turned off

      		 10 kΩ or higher
      3 - Body ground Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      1 - Body ground

      • Power switch on (IG)

      • Window Defogger turned off

      		 Below 1 V
      1 - Body ground

      • Power switch on (IG)

      • Window Defogger turned on

      		 11 to 14 V