RADIO RECEIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

    Click here

  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH

    Click here

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

    Click here

  7. REMOVE FRONT PANEL GARNISH LH

    Click here

  8. REMOVE FRONT PANEL GARNISH RH

    Click here

  9. REMOVE CONSOLE PANEL SUB-ASSEMBLY

    Click here

  10. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    1. A002144

      Remove the 4 bolts.

    2. Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 4 clips.

    3. Disconnect each connector and remove the radio receiver assembly with bracket.

  11. REMOVE NO. 1 RADIO BRACKET


    1. A002151

      Remove the 3 screws and No. 1 radio bracket.

  12. REMOVE NO. 2 RADIO BRACKET


    1. A0021CJ

      Remove the 3 screws and No. 2 radio bracket.

  13. REMOVE RADIO RECEIVER ASSEMBLY