AUDIO AND VISUAL SYSTEM(w/o Parking Assist Monitor System) Stereo Jack Adapter Light does not Illuminate

DESCRIPTION

Power is supplied to the No. 1 stereo jack adapter assembly illumination from the radio receiver assembly.

WIRING DIAGRAM

A0022K9E05
*a No. 1 Stereo Jack Adapter Assembly
*b Radio Receiver Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (NO. 1 STEREO JACK ADAPTER ASSEMBLY ILLUMINATION POWER SOURCE)


    1. Disconnect the K68 and K117 No. 1 stereo jack adapter assembly connectors.

    2. A00214UC13
      *a

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      K117-1 (USV1) - Body ground Power switch on (ACC) 5 V
      K68-12 (ACC) - K68-5 (GND) Power switch on (ACC) 11 to 14 V
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the K118 radio receiver assembly connector.

    2. Disconnect the K117 No. 1 stereo jack adapter assembly connector.

    3. A00232NC23
      *a

      Front view of wire harness connector

      (to Radio Receiver Assembly)
      *b

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K117-1 (USV1) - K118-1 (USV1) Always Below 1 Ω
      K117-1 (USV1) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the K75 radio receiver assembly connector.

    2. Disconnect the K68 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K75-3 (ACC2) - K68-12 (ACC) Always Below 1 Ω
      K75-3 (ACC2) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE RADIO RECEIVER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR