AUDIO AND VISUAL SYSTEM(w/o Parallel Parking Assist Function), Diagnostic DTC:B1324

DTC Code DTC Name
B1324 Lost Communication with Meter

DESCRIPTION

This DTC is stored when a communication error occurs between the radio receiver assembly and combination meter assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1324 Lost Communication with Meter After the radio receiver assembly receives a registration information signal, which is sent by the combination meter assembly when the power switch is on (ACC), 1 or more times, the radio receiver assembly cannot receive the signal for 30 seconds or more

  • Combination meter assembly

  • Radio receiver assembly

  • Harness or connector

WIRING DIAGRAM

A00218OE03
*a Combination Meter Assembly
*b Radio Receiver Assembly
*c Local Bus Communication Line

PROCEDURE


  1. CHECK DTC (METER / GAUGE SYSTEM)


    1. Check for DTCs and check that no DTCs are output.

      Click here


      Body Electrical > Combination Meter > Trouble Codes
      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    B

    GO TO METER / GAUGE SYSTEM Click here

    A

  2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - COMBINATION METER ASSEMBLY)


    1. Disconnect the K73 radio receiver assembly connector.

    2. Disconnect the K4 combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      K73-3 (CNH1) - K4-10 (MSCH) Always Below 1 Ω
      K73-4 (CNL1) - K4-9 (MSCL) Always Below 1 Ω
      K73-3 (CNH1) or K4-10 (MSCH) - Body ground Always 10 kΩ or higher
      K73-4 (CNL1) or K4-9 (MSCL) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE COMBINATION METER ASSEMBLY


    1. Replace the combination meter assembly.

      Click here

    2. Clear the DTCs.

      Click here


      Body Electrical > Navigation System > Clear DTCs

    3. Recheck for DTCs and check that no DTCs are output.


      Body Electrical > Navigation System > Trouble Codes
      OK
      No DTCs are output.
      Result
      Proceed to
      OK
      NG

    OK

    END

    NG

    REPLACE RADIO RECEIVER ASSEMBLY Click here