TILT AND TELESCOPIC MANUAL SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL TILT AND TELESCOPIC SWITCH


    1. Engage the claw to install the tilt and telescopic switch.

    2. Connect the tilt and telescopic connector to the tilt and telescopic switch.

    3. Connect the airbag connector to the spiral cable with sensor sub-assembly.

  2. INSTALL STEERING COLUMN COVER (for Lower Side)


    1. Engage the 2 claws to install the steering column cover (lower).

    2. Install the 3 screws.

  3. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  4. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  5. INSTALL STEERING WHEEL ASSEMBLY

    Click here

  6. CHECK STEERING WHEEL CENTER POINT

  7. INSTALL HORN BUTTON ASSEMBLY

    Click here

  8. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

    Click here