TILT AND TELESCOPIC MANUAL SWITCH REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. REMOVE HORN BUTTON ASSEMBLY

    Click here

  4. REMOVE STEERING WHEEL ASSEMBLY (w/ Pre-collision System)

    Click here

  5. REMOVE STEERING WHEEL ASSEMBLY (w/o Pre-collision System)

    Click here

  6. REMOVE STEERING COLUMN COVER (for Lower Side)


    1. A0020SJ

      Remove the 3 screws.

    2. A0020IE

      Disengage the 2 claws and remove the steering column cover (lower).

  7. REMOVE TILT AND TELESCOPIC SWITCH


    1. A0021KVC01
      *a Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    2. A0020BJ

      Disconnect the tilt and telescopic connector from the tilt and telescopic switch.

    3. Disengage the claw and pull out the tilt and telescopic switch.