HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


    1. Tie the string that was passed through the engine compartment to the end of the hood lock control cable assembly.

    2. A0020L8C02
      *1 Hood Lock Control Cable Assembly
      *2 Grommet

      Pass the hood lock control cable assembly through the grommet as shown in the illustration.

    3. Disconnect the string from the hood lock control cable assembly.

    4. Pass the hood lock control cable assembly through the upper radiator support.

    5. Engage the 5 clamps and install the hood lock control cable assembly.

  2. INSTALL UPPER FRONT FENDER PROTECTOR

    Click here

  3. INSTALL HOOD LOCK CONTROL CABLE COVER (w/ Cover)


    1. Engage the 2 claws.

    2. Install the hood lock control cable cover with the 2 screws.

  4. INSTALL HOOD LOCK ASSEMBLY


    1. A0022Y0

      Apply MP grease to the sliding areas of the lock.

    2. Connect the hood lock control cable assembly.

    3. Install the hood lock assembly with the 3 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    4. Connect the connector.

  5. INSTALL HOOD LOCK RELEASE LEVER PROTECTOR


    1. Engage the 2 clamps.

    2. Install the hood lock release lever protector with the 2 clips.

  6. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. Connect the hood lock control cable assembly and install the hood lock control lever sub-assembly.

  7. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  9. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  10. INSTALL COOL AIR INTAKE DUCT SEAL

    Click here

  11. ADJUST HOOD SUB-ASSEMBLY

    Click here