HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL

PROCEDURE


  1. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Dynamic Radar Cruise Control System)

    Click here

  3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

    Click here

  5. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A0022IA

      Disconnect the hood lock control cable assembly to remove the hood lock control lever sub-assembly.

  6. REMOVE HOOD LOCK RELEASE LEVER PROTECTOR


    1. A0020XT

      Remove the 2 clips.

    2. Disengage the 2 clamps to remove the hood lock release lever protector.

  7. REMOVE HOOD LOCK ASSEMBLY


    1. A0021X8

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. A0021HM

      Disconnect the hood lock control cable assembly to remove the hood lock assembly.

  8. REMOVE HOOD LOCK CONTROL CABLE COVER (w/ Cover)


    1. A00238V

      Remove the 2 screws.

    2. Disengage the 2 claws to remove the hood lock control cable cover.

  9. REMOVE UPPER FRONT FENDER PROTECTOR

    Click here

  10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY


    1. A0021MT

      Tie a string to the end of the hood lock control cable assembly.

      Tech Tips

      Use a length of string long enough to pass through the engine compartment.

    2. A00231HC01
      *1 Hood Lock Control Cable Assembly
      *2 Grommet

      Pull out the hood lock control cable assembly from the grommet as shown in the illustration.

      Tech Tips

      Leave the string inside the grommet.

    3. Disconnect the string from the hood lock control cable assembly.

    4. Using a screwdriver, disengage the 5 clamps.

      A0020HUC02
      *1 Hood Lock Control Cable Assembly *2 Clamp

      Tech Tips

      Tape the screwdriver tip before use.

    5. Pull the hood lock control cable assembly from the engine compartment to remove it.