STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL STEERING SHAKE DAMPER


    1. Install the steering shake damper to the steering wheel sub-assembly with the 2 screws.

      Torque:
      2.35 N*m  { 24 kgf*cm, 21 in.*lbf }

  2. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)


    1. Connect the connector to the steering wheel heater control assembly.

    2. Engage the clamp.

    3. Install the steering wheel heater control assembly to the lower steering wheel boss cover with the 2 screws.

      Torque:
      0.835 N*m  { 9 kgf*cm, 7 in.*lbf }

  3. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)


    1. Engage the 5 guides to install the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire to the steering wheel assembly.

    2. Install the 2 shift paddle switches (transmission shift switch assemblies) to the steering wheel assembly with 4 new screws.

      Torque:
      1.7 N*m  { 17 kgf*cm, 15 in.*lbf }

  4. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


    1. Install the cruise control switch wire.

  6. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  7. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  8. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  9. INSTALL STEERING WHEEL ASSEMBLY


    1. A011MR8C01
      *a Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 443 in.*lbf }

    3. w/ Steering Heater:


      1. Connect the connector to the steering wheel heater control assembly.

    4. Connect each connector to the spiral cable with sensor sub-assembly.

  10. CHECK STEERING WHEEL CENTER POINT

  11. INSTALL HORN BUTTON ASSEMBLY

    Click here