Click here

STEERING WHEEL REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

Note:

  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Click here

PROCEDURE


  1. Click here

    ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. Click here

    REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. Click here

    REMOVE STEERING WHEEL ASSEMBLY


    1. Disconnect each connector from the spiral cable with sensor sub-assembly.

    2. w/ Steering Heater:


      1. A011NJB

        Disconnect the connector from the steering wheel heater control assembly.

    3. A011MR8C01
      *a Matchmark

      Remove the steering wheel assembly set nut.

    4. Put matchmarks on the steering wheel assembly and steering main shaft.

    5. A011Q66C01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      09950-50013 09951-05010 09952-05010 09953-05020 09954-05070
      Note:

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. Click here

    REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  5. Click here

    REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  6. Click here

    REMOVE CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


    1. Remove the cruise control switch wire.

  7. Click here

    REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)


    1. A01CZK5

      Remove the 4 screws, and separate the 2 shift paddle switches (transmission shift switch assemblies) from the steering wheel assembly.

    2. A0020OM

      Disengage the 5 guides to remove the 2 shift paddle switches (transmission shift switch assemblies) with No. 1 switch wire from the steering wheel assembly.

  8. Click here

    REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)


    1. A011MF3

      Remove the 2 screws.

    2. Disengage the clamp.

    3. Disconnect the connector and remove the steering wheel heater control assembly from the lower steering wheel boss cover.

  9. Click here

    REMOVE STEERING SHAKE DAMPER


    1. A011OPG

      Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.