STEERING WHEEL(w/o Pre-collision System) REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly with the auxiliary battery connected and the power switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. A0020E8

      Disconnect 2 connectors from the spiral cable with sensor sub-assembly.

    2. w/ Steering Heater:


      1. A0022Q9

        Disconnect the connector from the steering wheel heater control assembly.

    3. A0022GRC01
      *a Matchmark

      Remove the steering wheel assembly set nut.

    4. Put matchmarks on the steering wheel assembly and steering main shaft.

    5. A0021Q9C01
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  6. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    Click here

  7. REMOVE NO. 2 SWITCH WIRE


    1. Remove the No. 2 switch wire.

  8. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)


    1. A0020OQ

      Remove the 2 screws.

    2. Disengage the clamp.

    3. Disconnect the connector and remove the steering wheel heater control assembly from the lower steering wheel boss cover.

  9. REMOVE STEERING SHAKE DAMPER


    1. A00212P

      Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.