REAR BRAKE REASSEMBLY

PROCEDURE


  1. INSTALL REAR DISC BRAKE BLEEDER PLUG

    Tech Tips

    Fully tighten the rear disc brake bleeder plug after bleeding the system.

  2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP

  3. INSTALL PISTON SEAL


    1. A011P9TC03
      B003YLR Lithium Soap Base Glycol Grease

      Apply lithium soap base glycol grease to the entire circumference of a new piston seal.

    2. Install the piston seal to the rear disc brake cylinder.

      Note

      Securely install the piston seal into the groove of the rear disc brake cylinder.

  4. INSTALL REAR DISC BRAKE PISTON


    1. A011NVQC01
      *1 Rear Disc Brake Piston
      *2 Cylinder Boot
      B003YLR Lithium Soap Base Glycol Grease

      Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.

    2. Install the cylinder boot to the rear disc brake piston.

    3. Apply a light layer of lithium soap base glycol grease to the contact surfaces of the rear disc brake piston, and install it to the rear disc brake cylinder.

      Note

      Do not forcibly install the rear disc brake piston into the rear disc brake cylinder.

  5. INSTALL CYLINDER BOOT


    1. A011OHS

      Install the cylinder boot to the rear disc brake cylinder.

      Note


      • Securely install the cylinder boot into the groove of the rear disc brake cylinder and groove of the rear disc brake piston.

      • Do not damage the cylinder boot.