REAR BRAKE DISASSEMBLY

PROCEDURE


  1. REMOVE REAR DISC BRAKE PISTON


    1. A011Q9PC01
      *a Cloth

      Place a piece of cloth between the rear disc brake piston and rear disc brake cylinder.

    2. Apply compressed air to remove the rear disc brake piston from the rear disc brake cylinder.

      CAUTION:

      Do not place your fingers in front of the rear disc brake piston when using compressed air.

      Note

      Do not allow any brake fluid to spatter.

  2. REMOVE CYLINDER BOOT


    1. A011O5MC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, remove the cylinder boot from the rear disc brake cylinder.

      Note

      Be careful not to damage the rear disc brake cylinder.

  3. REMOVE PISTON SEAL


    1. A011QKIC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the rear disc brake cylinder.

      Note

      Do not damage the inner surface or piston seal groove of the rear disc brake cylinder.

  4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

  5. REMOVE REAR DISC BRAKE BLEEDER PLUG