BRAKE MASTER CYLINDER(for RHD) REMOVAL

CAUTION / NOTICE / HINT

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE FRONT WHEEL RH

  3. REMOVE ABS MOTOR RELAY

    Click here

  4. PERFORM ACCUMULATOR ZERO DOWN

    Click here

  5. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  6. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Tech Tips

    Use the same procedure as for LHD.

    Click here

  7. REMOVE SKID CONTROL ECU ASSEMBLY

    Click here

  8. DISCONNECT NO. 1 RESERVOIR HOSE

    Click here

  9. REMOVE BRAKE ACTUATOR WITH BRACKET

    Click here

  10. REMOVE NO. 3 ENGINE ROOM RELAY BLOCK


    1. A0020ME

      Disengage the claw and separate the No. 3 engine room relay block from the skid control ECU bracket assembly.

  11. REMOVE SKID CONTROL ECU BRACKET ASSEMBLY


    1. A0020R8

      Disengage the fuel tube clamp from the skid control ECU bracket assembly.

    2. Remove the 3 bolts and skid control ECU bracket assembly.

  12. REMOVE BRAKE PEDAL RETURN SPRING


    1. A0021F8

      Remove the brake pedal return spring from the steering column assembly and push rod pin.

  13. REMOVE PUSH ROD PIN

    Click here

  14. DISCONNECT NO. 1 RESERVOIR HOSE


    1. A0022JB

      Slide the clip and disconnect the No. 1 reservoir hose from the brake master cylinder sub-assembly.

  15. REMOVE BRAKE MASTER WITH STROKE SIMULATOR CYLINDER ASSEMBLY


    1. A0022SA

      Disengage the wire harness clamp and disconnect the connector from the brake master cylinder sub-assembly.

    2. A0021SW

      Using a union nut wrench, disconnect the No. 1 brake actuator tube and No. 2 brake actuator tube from the brake master cylinder sub-assembly and brake stroke simulator cylinder sub-assembly.

      Note


      • Do not damage or deform the brake lines during the removal procedure.

      • Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.

    3. A0020RE

      Remove the 4 nuts, brake master with stroke simulator cylinder assembly, No. 1 brake actuator tube and No. 2 brake actuator tube.

      Note

      Do not kink or damage the brake lines.

  16. REMOVE BRAKE BOOSTER GASKET

  17. REMOVE BRAKE STROKE SIMULATOR TUBE

    Tech Tips

    Use the same procedure as for LHD.

    Click here

  18. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY


    1. Remove the brake master cylinder sub-assembly from the brake stroke simulator cylinder sub-assembly.

      Tech Tips

      Use the same procedure as for LHD.

      Click here