Click here

SKID CONTROL ECU(for RHD) REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. Click here

    REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. Click here

    DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

    Click here

  4. Click here

    REMOVE SKID CONTROL ECU ASSEMBLY


    1. A0021O2

      Remove the bolt and 2 nuts and separate the skid control ECU assembly from the vehicle body.

    2. Disengage the wire harness clamp from the skid control ECU assembly.

    3. A0022INN01

      Release each lock lever and disconnect the 2 connectors (A) from the skid control ECU assembly.

    4. Disconnect the connector (B) to remove the skid control ECU assembly.