REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • The speed sensor rotor is a component of the rear axle hub and bearing assembly. If the speed sensor rotor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY SERVICE HOLE COVER LH

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE LUGGAGE COMPARTMENT FLOOR MAT (for RH Side)

    Click here

  5. REMOVE LUGGAGE COMPARTMENT TRIM BOX (for RH Side)

    Click here

  6. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER (for RH Side)

    for Fixed Seat Type: Click here

    for Fold Down Seat Type: Click here

  7. REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER (for RH Side)

    Click here

  8. SEPARATE LUGGAGE COMPARTMENT TRIM COVER RH (for RH Side)


    1. B003Y9K

      Disengage the 4 claws and open the 2 covers.

    2. B003XSI

      Remove the 2 bolts and rope hook assemblies.

    3. A0021U0

      Remove the 4 clips.

    4. Separate the luggage compartment trim cover RH from the body.

  9. REMOVE REAR WHEEL

  10. SEPARATE REAR WHEEL HOUSE LINER


    1. A002249

      Remove the 2 nuts and separate the rear wheel house liner.

  11. REMOVE REAR SPEED SENSOR


    1. for RH Side:


      1. Turn back the luggage compartment trim cover RH until the rear speed sensor connector can be seen.

    2. Disengage the rear speed sensor connector.

      A0021VHC01
      *A for LH Side *B for RH Side
    3. A0020IJ

      Remove the 3 bolts and separate the rear speed sensor and 2 sensor clamps from the rear axle carrier sub-assembly and rear upper control arm assembly.

      Note


      • Prevent foreign matter from attaching to the rear speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the rear speed sensor is removed.

    4. Turn back the rear wheel house liner until the grommet can be disengaged.

    5. A0020Y2

      Remove the 2 nuts and 2 sensor clamps.

    6. Disengage the grommet and remove the rear speed sensor.