FRONT SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY

   Click here

   Tech Tips

   
   

   • If the sensor rotor needs to be replaced, replace the front axle hub sub-assembly.

   • The front speed sensor is a component of the front axle hub sub-assembly. If the front speed sensor is malfunctioning, replace the front axle hub sub-assembly.

2. INSTALL FRONT DISC

   Click here

3. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

   Click here

4. INSTALL SKID CONTROL SENSOR WIRE

   
   

   1. Connect the connector to install the skid control sensor wire.

   2. Install the bolt.

      Torque:

      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      Do not twist the skid control sensor wire when installing it.

   3. Return the front fender liner to its original position.

   4. 

      Engage the clamp to the front No. 1 stabilizer bracket.

   5. Install the 2 sensor clamps to the front shock absorber assembly and body with the 2 bolts.

      Torque:

      Bolt A

      13.5 N*m  { 138 kgf*cm, 10 ft.*lbf }

      Bolt B

      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      Do not twist the skid control sensor wire when installing it.

   6. Connect the connector to the front axle hub sub-assembly.

5. INSTALL FRONT FENDER LINER

   
   

   1. Install the front fender liner with the screw.

6. INSTALL FRONT WHEEL

   Torque:

   103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

   Click here

8. INSTALL BATTERY SERVICE HOLE COVER LH

   Click here

9. CHECK FOR SPEED SENSOR SIGNAL

   Click here