TIRE PRESSURE WARNING INITIATOR(for Rear Side) INSTALLATION

PROCEDURE

1. INSTALL REAR TIRE PRESSURE MONITOR INITIATOR

   
   

   1. Install the rear tire pressure monitor initiator with the 2 nuts.

      Torque:

      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

   2. Engage the grommet.

   3. Install the rear wheel house liner LH to its original position.

   4. Connect the connector.

2. INSTALL JACK ASSEMBLY

3. INSTALL BATTERY SERVICE HOLE COVER LH

   Click here

4. INSTALL REAR WHEEL LH

   Torque:

   103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

5. INSPECT TIRE PRESSURE WARNING SYSTEM

   Click here