TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE


  1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER


    1. Connect the connector to the tire pressure warning ECU and receiver.

    2. Engage the 2 hooks to temporarily install the tire pressure warning ECU and receiver.

    3. A0022FYC01
      *A Bolt A
      *B Bolt B

      Install the bolt.

      Torque:
      Bolt A
      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }
      Bolt B
      10.4 N*m  { 106 kgf*cm, 8 ft.*lbf }

      Note

      There are three types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

  2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY LH

    Click here

  3. INSTALL REAR SEAT SIDE GARNISH LH

    Click here

  4. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  5. INSTALL REAR SIDE SEATBACK ASSEMBLY LH (for Fold Down Seat Type)

    Tech Tips

    Use the same procedure as for the RH side.

    Click here

  6. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)

    Click here

  7. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

    Click here

  8. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)

    Click here

  9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Rear Seat Side Airbag)

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

    Click here

  10. INSTALL BATTERY SERVICE HOLE COVER LH (w/ Rear Seat Side Airbag)

    Click here

  11. INSPECT SRS WARNING LIGHT (w/ Rear Seat Side Airbag)

    Click here

  12. REGISTER TRANSMITTER ID

    Click here

  13. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

  14. PERFORM INITIALIZATION

    Click here