FRONT UPPER SUSPENSION ARM INSPECTION

PROCEDURE


  1. INSPECT FRONT UPPER SUSPENSION ARM ASSEMBLY


    1. A011NM4

      Inspect the turning torque of the ball joint.


      1. Install the nut to the front upper suspension arm assembly stud.

      2. Using a torque wrench, turn the stud continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

        Turning torque
        0.98 to 3.43 N*m (10 to 34 kgf*cm, 9 to 30 in.*lbf)

        If the turning torque is not within the specified range, replace the front upper suspension arm assembly with a new one.

    2. Inspect the dust cover.


      1. Check that the dust cover is not cracked and that there is no grease on it.

        If the dust cover is cracked or there is grease on it, replace the front upper suspension arm assembly with a new one.