ABSORBER CONTROL ACTUATOR(for Front Side) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL ABSORBER CONTROL ACTUATOR


    1. A0021KTC07
      *a 40°
      *b Control Rod

      Check that the control rod of the front shock absorber assembly is in the position shown in the illustration.

      Note

      If the control rod is not in the position shown in the illustration, turn the control rod to adjust the position before installing the absorber control actuator.

    2. A00210NC02
      *a Absorber Control Actuator Output Shaft
      *b Control Rod

      Install the absorber control actuator to the front actuator support bracket.

      Note

      Make sure to check that the absorber control actuator output shaft and control rod are securely connected.

    3. A0020HDC02
      *a 40°

      Turn the absorber control actuator clockwise 40° until a click is felt.

      Note


      • Before turning the absorber control actuator, make sure to check that the absorber control actuator output shaft and control rod are securely connected.

      • Do not turn the absorber control actuator more than 40°.

      • Do not drop the absorber control actuator. If it is dropped, replace it with a new one.

  2. INSTALL UPPER SHOCK ABSORBER CAP


    1. Install the wire harness to the upper shock absorber cap.

    2. Connect the connector.

    3. Install the upper shock absorber cap with the 3 nuts.

      Torque:
      19.6 N*m  { 200 kgf*cm, 14 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL BATTERY SERVICE HOLE COVER LH

    Click here