FRONT ACCELERATION SENSOR REMOVAL

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

   Click here

2. Click here

   REMOVE BATTERY SERVICE HOLE COVER LH

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

   Click here

4. Click here

   REMOVE FRONT DOOR SCUFF PLATE LH

   Click here

5. Click here

   REMOVE FRONT DOOR OPENING TRIM COVER LH

   Click here

6. Click here

   REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

   Tip:

   Use the same procedure for RHD and LHD.

   Click here

7. Click here

   REMOVE ACCELERATION SENSOR

   
   

   1. Fold back the floor carpet.

   2. 

      Disconnect the connector.

   3. Remove the 2 nuts and acceleration sensor.

      Note:
      

      • Avoid any impact to the acceleration sensor.

      • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.